How to make Colloidal Silver
The Type of Water to Use
The ONLY type of water you should use is distilled water, which has been distilled by water distillation (not reverse osmosis).
There are NO exceptions. All other types of water have too many impurities. While water impurities help speed up the cooking of the colloidal silver by allowing it to reach maximum conductivity sooner, the minerals in the water can bind to the silver particles and may eventually create a health condition known as argyria. Argyria is a condition where the skin turns gray or blue-gray because of taking high doses of impure colloidal silver over time. It may be irreversible, so it should be avoided. More on Argyria.
DO NOT ADD SALT OR ANYTHING ELSE TO THE WATER - PERIOD. While salt will allow current to flow, it may create silver chloride, which can cause argyria over time.
Do NOT add ANYTHING to the water if it will create a silver compound, such as silver chloride.
Do NOT add preservatives, minerals, EDTA, proteins, gelatin, coloring, honey, etc.
No matter what kind of water you use, if the water turns black, throw the water away, it has too many impurities in it.
Instructions For Cooking Colloidal Silver with and without starter solution
Heating the Water (sometimes recommended)
NOTE: If you are using a system other than The Silver Genie, these instructions might not be accurate.
Keep the power off while you are getting set up.
The first thing you want to do in the cooking process is to setup your processing station.
1. Insert the clip leads into the back of the Silver Genie.
(If you are operating with the batteries, skip step 2 & 3.)
2. Insert the power adaptor into the right side of the Silver Genie. Be sure the adaptor is NOT plugged in to the wall when connecting or disconnecting it to the Silver Genie, as this could damage the adaptor.
* See important Return & Warranty Policy.
3. Make sure the switch is off and plug the power supply into the wall.
4. Pour the 2oz of starter solution into the clear jar.
5. Fill the clear jar to the rib just below the lid threads with distilled water. Stir a little and you are now ready to setup the 16 oz. process. Your distilled water should be at least 80F.
**It is important that you never add salt or anything other than a silver solution (seed) as described above to the distilled water. With the silver seed, you have everything you need to safely speed the process as much as possible.
6. Place the clear jar in a convenient location near the Silver Genie. Put one silver rod on the rim of the jar and slide gently left/counter clockwise. The rod should be slightly snug. Do the same with the other rod so that they are arranged opposite each other. This should place the rods approximately 2 – 2 1/4 inches apart.
7. Hook 1 clip lead to each silver rod.
8. Press up on the switch to turn the Silver Genie on. The red LED should now be lit.
9. Go watch TV or something for (see table below for approx. time vs ppm) not more than 1 hr 40 minutes.
If you have a laser, shine it through the solution. Tyndall Effect (laser density) should be viewed in subdued light only. After 25 minutes you should be able to start seeing a faint laser line and will have produced a satisfactory batch of ionic colloidal silver. After 1 hour 40 minutes you should be able to see a very clear and bold laser line and you will have produced a very effective batch of Ionic Silver. The ability to see the laser beam as described indicates the concentration is between 5 to 20ppm. The darker the beam, the better, but if the solution even starts to turn yellow, you’re done. A slight yellow tint may be present, but is not necessary. It is not recommended to process the solution over 1 hour 40 minutes.
 |
If you would like a more accurate ppm estimate, probably the least expensive and accurate way would be to purchase say a 2 oz. bottle of (Ionic) Colloidal Silver in the ppm you desire from a Health Food Store to use as a standard to compare against your finished product. Compare the Tyndall Effect (laser density) in your solution with that of the standard solution you purchased. If the beam is lighter than the standard, you have less ppm and obviously if it is darker, you have more ppm than the standard. This would be a very good way to fine tune your process if you wish.
If you are not using starter solution, add 15 minutes to the overall time.
| Time | Concentration |
| 25 Min | 5ppm |
| 50 Min | 10ppm |
| 1 Hr | 12ppm |
| 1 Hr 15 Min | 15ppm |
| 1 Hr 30 Min | 18ppm |
| 1 Hr 40 Min | 20ppm |
1: Turn the Silver Genie off.
2: Remove the leads from the rods.
(If you are operating with the batteries, skip step 3 & 4)
*3: Unplug the cord from the wall.
*4: Disconnect the power adaptor from the right side of the Silver Genie. Be sure the adaptor is NOT plugged in to the wall when connecting or disconnecting it to the Silver Genie, as this could damage the adaptor.
* See important Return & Warranty Policy.
5: Remove the rods.
6: Using a small funnel, pour the Ionic Silver solution into your 16oz. amber bottle, straining it through an unbleached coffee filter placed in the funnel and you’re done.
It is recommended that you put 2 oz. of this batch back into the starter bottle for your next batch.
Other Comments
Whenever possible, The Silver Genie should be used with the adapter option.
The battery option should be considered as a backup source of power only, ie you need to make CS and conventional power is not available.
Store the Ionic Silver in an amber bottle, in a cool, dark place and NEVER REFRIGERATE IONIC SILVER.
Suggestion on How Much To Drink
This is up to the individual. If the Colloidal Silver is being used for prevention, 1 to 2 tblsp of 5 to 20ppm colloidal silver per day is all an adult would likely need. If there is a common cold, pandemic flu, or other type of flu, going around, then it would be best to double the daily dose for prevention.
If the Colloidal Silver is being used for treatment purposes, it might be best to take 1 to 2 ounces of colloidal silver a day, for as much as 2 or 3 weeks at a time.
If you are going to take the colloidal silver for several weeks at a time, make triple sure it is pure silver that is being used, and not silver chloride or some other silver compound.
!Disclaimer!
The Silver Genie Ad Links
The Silver Genie Partners Page
|
|
Support our troops, VOTE in every election.
Hours of Operation: Mon-Fri 9am-6pm PST
Partner Links
 |
Las Vegas, NV 89107
Phone 702-321-8248
Contact Us
©Copyright 2010 All Rights Reserved.
E-mail: Webmaster